Address: 241 Nguyen An Ninh Street, Long An Ward, Tay Ninh Province, Vietnam Call: +84 394 552 839
PK LASERTẬN TÂM TẬN LỰC
Home / Solutions / WSX Laser Cutting Head (KC15, NC30, NC60): Spare Parts and Common Faults

PK LASER · PK LASER Joint Stock Company

WSX Laser Cutting Head (KC15, NC30, NC60): Spare Parts and Common Faults

WSX laser cutting heads KC15, NC30, NC60: structure, protective lens, collimating lens, ceramic ring, sensor, choosing the right part code and fixing common faults. Zalo: 0394 552 839.

WSX cutting heads supplied by PK LASER

PK LASER supplies and supports the WSX KC15, the WSX NC30 auto-focus head and the WSX NC60. Each model suits a different laser power range. Send your laser power, material and usual thickness on Zalo and our technicians will recommend the right model.

Structure of the WSX auto-focus head

According to the manufacturer's user manual (Shenzhen Worthing Technology), the head includes:

  • QBH fiber connector at the top.
  • Three pairs of cooling-water connectors, plus separate cutting-gas and cooling-gas ports.
  • X and Y centering screws to align the beam with the nozzle.
  • Encoder, limit-switch and focus-motor signal ports.
  • An observation window and three protective windows.
  • Collimating and focusing lens groups inside.
  • Ceramic ring and nozzle at the bottom.

Spare parts that wear most

  • Protective lens: replace when it shows burn spots, pitting, or cutting gets weaker.
  • Collimating lens: replace when dirty or burned, usually after a protective lens was not changed in time.
  • Focusing lens: replace when burned or cracked.
  • Ceramic ring (Precitec/WSX type): replace when cracked, chipped or loose after a collision.
  • Nozzle: replace when dented, worn or covered in dross.
  • Height sensor and sensor cable: check when height tracking is unstable.

How to choose the right part code

  • Identify the exact model on the head label or in the control software.
  • Measure or photograph the old part: lens diameter and thickness, nozzle thread, ceramic ring type.
  • Send the photos on Zalo 0394 552 839 so a technician can confirm the code before delivery.

Common faults and what to check

Cutting gets weaker: check the protective lens first.

Height-sensor alarm or bobbing head: check nozzle, ceramic ring, sheet, capacitance calibration, then the sensor cable.

Clean cut on one side, burrs on the other: the nozzle is off-center or dented; replace it and re-center.

Head runs hot: check cooling water and all lenses. Burned internal lenses should be inspected by a technician in a clean area.

Maintenance based on the user manual

Turn off power, cooling gas and cutting gas before working on the head. Blow dust off with compressed air and clean parts with a clean cloth and alcohol. Record the position and direction of each lens before removing it, remove parts in the direction shown by the manufacturer, and never use a wrench or pliers. After replacing the ceramic ring or nozzle, recalibrate and check beam centering. When connecting the fiber, keep the head horizontal, clean the QBH, align the red marks and tighten by hand only.

Repair and on-site support

PK LASER inspects WSX heads, replaces parts, fixes sensor faults and provides on-site support in Ho Chi Minh City, Long An, Tay Ninh, Binh Duong and the Mekong Delta. Zalo: 0394 552 839. Technical line: 0394 542 839.

Contact us

Business inquiries: +84 394 552 839

Technical support: +84 394 542 839

Email: pklasercnc@gmail.com