PK LASER · PK LASER Joint Stock Company
Raytools Laser Cutting Head (BM06K, BM109–BM115, BT240S): Parts and Common Faults
Raytools laser cutting heads BM06K, BM109, BM110, BM111, BM114, BM115 and BT240S: spare parts, choosing the right code and fixing common faults. Zalo: 0394 552 839.
Raytools heads supplied by PK LASER
Auto-focus BM series (focus changed by motor from the software): BM06K, BM109, BM110, BM111, BM114 and BM115. Manual-focus model: BT240S. Each model suits a different power range and machine type. Send your laser power, material and usual thickness on Zalo for a recommendation.
Spare parts for Raytools heads
- Protective lens, including the genuine Raytools D37×7: replace when burned, pitted or cutting weakens.
- Raytools lens seal ring: replace when deformed or hardened.
- Collimating lens for BM109 and BM111: replace when dirty or burned.
- Focusing lens: replace when burned or cracked.
- Raytools ceramic ring and D32 ceramic ring: replace when cracked, chipped or causing sensor alarms.
- Nozzle: replace when dented, worn or covered in dross.
- Raytools height sensor and sensor cable: check when height tracking is unstable.
How to choose the right part code
- Read the exact model on the head label (BM06K, BM111, BT240S…). Different models use different lenses, ceramic rings and nozzles.
- Measure or photograph the old part.
- Send the photos on Zalo 0394 552 839 to confirm the code before delivery.
Common faults and what to check
Cutting gets weaker: check the protective lens first.
Height-sensor alarm: check nozzle, ceramic ring, sheet, capacitance calibration, then the cable.
Off-center or one-sided burrs: replace the nozzle and re-center it with tape.
Auto-focus does not reach the right focus (BM series): check focus parameters in the software, the limit-switch signal and the focus-motor cable. Do not open the motor assembly yourself; contact a technician if the fault repeats.
Maintenance
- Turn off laser emission and gas before removing lenses, nozzles or ceramic rings.
- Check the protective lens every shift and clean it with swabs and lens-cleaning solution.
- Replace the lens seal ring when it hardens.
- Check nozzle and ceramic ring after every collision.
- Run capacitance calibration after replacing the nozzle or ceramic ring.
- Drain water and check the air filter and dryer regularly.
Repair and on-site support
PK LASER inspects Raytools heads, replaces parts and fixes sensor faults, with on-site support in Ho Chi Minh City, Long An, Tay Ninh, Binh Duong and the Mekong Delta. Zalo: 0394 552 839. Technical line: 0394 542 839.