Address: 241 Nguyen An Ninh Street, Long An Ward, Tay Ninh Province, Vietnam Call: +84 394 552 839
PK LASERTẬN TÂM TẬN LỰC
Home / Solutions / Laser Cutting Head Ceramic Ring: Signs of Damage, Choosing the Right Type and Replacement

PK LASER · PK LASER Joint Stock Company

Laser Cutting Head Ceramic Ring: Signs of Damage, Choosing the Right Type and Replacement

Ceramic rings for Raytools, Precitec, WSX and Ospri laser cutting heads: what they do, signs of cracking, choosing the right type and safe replacement steps. Zalo: 0394 552 839.

What the ceramic ring does

The ceramic ring sits between the cutting-head body and the nozzle. It is small and inexpensive, but a cracked or loose ring causes sensor alarms, a bobbing head and ruined parts.

  • Holds the nozzle in position, concentric with the beam.
  • Insulates the nozzle from the head body and forms part of the capacitive height-measuring circuit.
  • Absorbs impacts when the head hits the sheet, protecting the more expensive parts above.

Signs of a damaged ceramic ring

Sensor alarms can also come from the nozzle, the sheet or the cable, so check them in order.

  • Height-sensor alarm, or the head bobs or lifts during cutting.
  • Visible hairline cracks, chipped edges, or a ring that wobbles.
  • The nozzle sits off-center: clean cut on one side, burrs on the other.
  • Capacitance calibration fails after a heavy collision.

Choose the ring that matches your head

Each brand uses a different size, contact pin and thread. A wrong ring will not fit, or will fit but measure height incorrectly. PK LASER stocks Raytools ceramic rings, D32 rings for Raytools, Precitec/WSX rings and Ospri rings. If unsure, send photos of the old ring (top and bottom) and the head label on Zalo 0394 552 839.

Replacement steps

  • Turn off laser emission, cutting gas and cooling gas. Let the head cool.
  • Blow dust from around the head with compressed air.
  • Remove the nozzle, then the locking ring and old ceramic ring by hand. Never clamp the ring with pliers or a wrench.
  • Clean the contact faces with a clean cloth and alcohol; check the contact pin and seals.
  • Fit the new ring the right way round on its locating pin and tighten the locking ring by hand.
  • Refit the nozzle, run capacitance calibration and re-center the nozzle with tape.

Making ceramic rings last longer

  • Enable collision avoidance and travel paths that avoid cut parts.
  • Keep sheets flat so the head does not scrape warped plate.
  • Inspect the ring after every collision, even without an alarm.
  • Keep one or two spare rings of the correct code.

Quick answers

A slightly cracked ring should not be reused: it makes height readings unstable and can break completely at the next impact. If the alarm remains after replacement, check the nozzle, recalibrate and inspect the sensor cable, or call PK LASER for on-site service. Zalo: 0394 552 839. Technical line: 0394 542 839.

Contact us

Business inquiries: +84 394 552 839

Technical support: +84 394 542 839

Email: pklasercnc@gmail.com